InstrumentationBiofouling Control in Marine Instruments via UVC LEDsBy Hari Venugopalaniofouling is the accumulation of microorganisms, and marine environments where the impact on optical sensors plants, algae, or other organisms on wetted surfac- can occur within a week of deployment.es. The mechanism of fouling involves the initial In the marine environment, biofouling affects both optical Bbacterial attachment and formation of a bio? lm on and non-optical sensors used for water quality and conduc-the surface, followed by the attachment of larger marine or- tivity measurements as well as acoustic sensors (sonar) for ganisms. Biofouling affects a range of systems and compo- ocean current measurement, underwater cameras, lighting, nents across many industries, especially those in the coastal and lenses used for optical communication. In ocean monitor-ing, biofouling has long been considered as a limiting factor to the length of deployment for underwater instruments and sen-sors. The Alliance for Costal Technologies has estimated that Figure 1maintenance costs due to biofouling can consume as much as Duration of deployment before biofouling 50% of operational budgets.negatively impacts monitoring equipment. Source: M. Faimali et al., Report on biofouling prevention Methods, 2014]Traditional Biofouling Control MethodsThere are several methods of biofouling control that have been traditionally used with limited success. Biocides have been used due to their high level of effectiveness, but they are largely being phased out due to environmental regulations. The most common biocide over the past 40 years, Tributyltin Figure 2Arrangements of two UVC LEDs outside the quartz conductivity cell to achieve uniform distribution of light within the cell. March 201624 MTRMTR #2 (18-33).indd 24 2/19/2016 11:08:04 AM